| FA12025 | Where can the embedded Ethernet port of M340 PLC used The embedded Ethernet port on the M340 processors can be used to connect to the Schneider Electric Magelis range of HMI. For IO scanning NOE module... |
| FA12145 | Is the remote keypad option available for Altivar 21 Drive. Yes, the remote keypad option is available for the Altivar 21 Drive. The reference for the same is VW3A21101. It can be installed remotely up to a... |
| FA22663 | Is TeSys U suitable for DC Motor applications. All control unit of Tesys U are designed for AC load applications only.
Due to the TeSys U design specifications and accessories limitations, it... |
| FA22653 | Is it possible to use the current Limiter LA9LB920 or GV1L3 with Tesys GV3 range of MPCB to increase the breaking capacity. LA9LB920 and GV1L3 current limiter are dedicated to Tesys GV2 Motor Protection Circuit Breaker (MPCB) product range and can be used with MPCB rated... |
| FA12216 | What is the maximum number of sensors and resistance values which can be connected to the T1 and T2 terminals on TeSys T. You can wire maximum 6 sensors (PTC or NTC analog) to Temperature Input terminals T1 and T2 on TeSys T.And, you can go up to a maximum of 6500 ohms... |
| FA12215 | Can TeSys T be used downstream of Altivar range Variable Speed Drive. The Current Transformers (CTs) of TeSys T are deigned to work under the frequency range between 47 to 63 Hz only. However, the output frequency range... |
| FA12192 | Is it possible to control the motor from TeSys T via the PowerSuite software. The configuration of TeSys T, read diagnostic, parameter setting and custom logic development is possible via PowerSuite software.However, the controls... |
| FA12191 | Is it possible to connect the different control voltages at the input of LTMR module in TeSys T. Control Voltage characteristics You can connect different control voltages on the input of the LTMR TeSys T module, if the voltage and current ratings... |
| FA12193 | What is the maximum current which can be measured by TeSys T. 810 A is the maximum current that can be measured by the TeSys T as per the Schneider Electric offer catalogue.However, as per the TeSys T hardware/software... |
| FA12196 | Can TeSys T be used for Single Phase application. Yes, TeSys T can be used in Single Phase application. For a Single Phase application, you pass the First Phase cable through the first internal CT... |