| FA12146 | Is the Automatic adaptation of deceleration ramp feature available in Altivar 61 drive. Automatic adaptation of deceleration ramp feature is available in Altivar 61 drive.
It assists in prevention of over voltage fault, in case the user... |
| FA12149 | How Altivar 61 Drive can be auto started after Power ON. In order to avail the auto start facility after Power ON, following Parameters have to be programmed as below: In [1.5 INPUTS/OUTPUTS CFG](I-O) Menu. 1.... |
| FA12132 | What is the Earth Leakage current value for an Altivar 31 Drive. Refer attachment for the Earth Leakage current values for Altivar 31 Drive.Note: The earth leakage current strongly depends on how well the input... |
| FA12122 | What is the setup procedure to establish the communication of Altivar 21 Drive via ModBus RTU or ModBus Network. The procedure for communication setup of the Altivar 21 Drive via ModBus RTU or ModBus Network is as follows: 1. Pass the register address of Altivar... |
| FA12197 | What is the Cross-sectional area of the Bus Bar conductors in Canalis KSA range. The Cross-sectional area of the Bus Bar Phase and Neutral conductors in Canalis KSA range are as tabulated below: Model Number... |
| FA22654 | What is the significance of two arrows on the knob of Tesys GV3P Current Setting Dial. The first black arrow needs to be set at the rated current of Motor, when Tesys GV3 MPCB is used with contactor separately mounted or not used at... |
| FA12216 | What is the maximum number of sensors and resistance values which can be connected to the T1 and T2 terminals on TeSys T. You can wire maximum 6 sensors (PTC or NTC analog) to Temperature Input terminals T1 and T2 on TeSys T.And, you can go up to a maximum of 6500 ohms... |
| FA12192 | Is it possible to control the motor from TeSys T via the PowerSuite software. The configuration of TeSys T, read diagnostic, parameter setting and custom logic development is possible via PowerSuite software.However, the controls... |
| FA12082 | What is the explanation of the Parameter FLC1 in TeSys T. FLC1 is the parameter to enter the Motor nominal current in TeSys T. In this parameter, the Motor nominal current is entered as a percentage of the... |
| FA12187 | Is it possible to give Start/Stop commands from PLC via Modbus Port on LUCM module of TeSys U. You can connect the Modbus port of LUCM module (Multi Functional Control Unit) of TeSys U controller with PLC in order to access all the registers,... |