Narrow By
  1. Your SelectionRemove All

Settings - FAQs

FAQ Search
>   Select Language
Most Recently Published FAQs

Results 41 - 50 of 66

FAQ ID Description
FA22631What is the reference of Type A or Type B thermostat in Prisma Plus switchboard.
Type C thermostat is available in Prisma Plus, the part reference of which is 08998. The Type C thermostat Reference 08998 can be used as Type A or...
FA22627Can impulse-type power supply be used for electrical opening and closing order of Compact NS MCCB.
Yes, the impulse-type power supply (time duration > 20 ms and Voltage level above 0.7Un) can be used for electrical opening and closing of Compact...
FA22628Is it possible to get the Earth Fault alarm only without tripping in Compact NSX with Micrologic 6, via Modbus communication.
Yes, only the Earth Fault alarm can be achieved in Compact NSX with Micrologic 6A/6E without tripping the MCCB at Earth Fault.   For this, Ground...
FA21071How do the program and data get stored in the memory of PLC
In case no memory extension card is used with PLC, then the program data and constants are stored in the internal RAM memory of the processor module...
FA22606What is the minimum and maximum rated voltage on which the Vigi C120 can operate.
The minimum/maximum rated voltage on which Vigi C120 range can operate is as follows:   For VigiC120 30mA - Minimum Voltage 196V / Maximum Voltage...
FA21085Is it possible to configure ring topology with Modbus and Modbus Plus communication networks.
Modbus and Modbus Plus networks support line and star topology only. These networks cannot be configured in ring topology. However, it is possible...
FA12125What is the meaning of the Speed-range ratio in Altivar 61/71 Range Drives.
The Speed-range ratio for Drives is 20:1, 100:1 or 1000:1. This is an indication of how slow the Drive can run the motor, before the motor starts...
FA12181Does the Energy Reading remain stored for ME range Energy Meters during power failure.
Yes, the Energy Readings remain stored for the ME range meters during power failure as they are stored in the EEPROM.EEPROM is nonvolatile memory...
FA11886What is the Pin out detail for the Modbus programming cable 110 XCA 20 3000.
The pin out details of the Modbus programming cable 110 XCA 20300 is as shown below.  
FA12127What is the minimum time interval allowed between two consecutive peaks of 220% Torque (Tn) in Altivar 71 Drive.
The Altivar 71 Drive can deliver the peak Torque (Tn) of 220% consecutively within a minimum time interval of 5 minutes.

Results 41 - 50 of 66