| FA22661 | Can the OA1 output of Tesys U be used with multifunction unit to drive a separate motor contactor. Output OA1 for Tesys U with base contactor (LUB**) is only used to drive the contactor embedded inside the TesysU contactor base LUB.
In order to use... |
| FA22654 | What is the significance of two arrows on the knob of Tesys GV3P Current Setting Dial. The first black arrow needs to be set at the rated current of Motor, when Tesys GV3 MPCB is used with contactor separately mounted or not used at... |
| FA22660 | What are the safety clearance dimensions for a LC1B range contactor switching with the DC voltage. The safety clearance distances are as per the below table. These values are given for AC voltage; however these values are same as in case of DC voltage.
Note:... |
| FA22658 | What are the main DC power supply voltage and current ratings of LC1F115 & LC1F150 Contactors. The LC1D115/150 was launched in 1996 in order to substitute the LC1F115/150 in the future, and offer better performances using an improved design.
For... |
| FA22657 | Is it possible to use Tesys range contactors under H2S (hydrogen sulfide) environment. If yes, what is the maximum limit. To ascertain that our products can reach acceptable average lifetime, the ambient air concentration of a given corrosive gas must comply with following... |
| FA22659 | Can the same mechanical interlock for LC1FL44 contactor be used for mechanical interlock of the new equivalent LC1F6304 contactor. Yes, the same mechanical interlock LA9FL970 can be used for both the old LC1FL44 as well as for new equivalent LC1F6304 contactors. This is a horizontally... |
| FA22653 | Is it possible to use the current Limiter LA9LB920 or GV1L3 with Tesys GV3 range of MPCB to increase the breaking capacity. LA9LB920 and GV1L3 current limiter are dedicated to Tesys GV2 Motor Protection Circuit Breaker (MPCB) product range and can be used with MPCB rated... |
| FA12217 | Can TeSys range overload relays be used in DC application. The overload relay with the bimetal technology (Thermal Overload) only can be used in DC application. Tesys LRD RangeTesys LRD thermal overload relays... |
| FA12216 | What is the maximum number of sensors and resistance values which can be connected to the T1 and T2 terminals on TeSys T. You can wire maximum 6 sensors (PTC or NTC analog) to Temperature Input terminals T1 and T2 on TeSys T.And, you can go up to a maximum of 6500 ohms... |
| FA12221 | What is the Resistance value used in the capacitive contactor LC1D*K range. Refer attachment for the resistance values used in the capacitive contactor LC1D*K range. |